Worx WX661 Instruction Manual download pdf (Page 10)

Belt sander WX661 WX661.1

OPERATING INSTRUCTIONS

NOTE: Before using the tool, read the instruction

book carefully.

INTENDED USE

The machine is intended for dry sanding–with high

removal capacity–of wood, plastic, metal, ﬁller as well

as varnished surfaces.

1. ON/OFF SWITCH

Depress to start and release to stop your tool.

2. SWITCH LOCK-ON BUTTON (See Fig. A)

Depress on/off switch (2) then lock on button (3). Your

tool is now locked on for continuous use. To switch off

your tool just depress and release the on/off switch.

3. VARIABLE SPEED CONTROL DIAL

Adjust the variable speed control (1) to increase or

decrease the speed according to the material and

sanding belt speciﬁcation to be used (also possible

during no load operation). See the table below for

general guidance on speed selection. Avoid prolonged

use at very low speed as this may damage your

sander’s motor.

Material Speed selection Belt Grit

Solid Wood 5-6 80

Veneer 2-4 150

Chipboard 1-5 60/80

Plastics 2-5 100

Steel 5-6 80

Paint

Removal

6 40/60

Balsa Wood 1-3 100

Acrylic 1-2 100

4. CHANGING A SANDING BELT (See Fig. B, C)

WARNING! Remove the main plug from the

socket before changing sanding belt.

Pull the lever (7) to release the belt tension. Remove

and ﬁt a new belt over both rollers. Ensure the direction

of rotation arrows on the belt and the sander are the

same. Close the lever to tension the belt.

13a

13b

1 2 ... 5 6 7 8 9 10 11 12 13

No comments

Worx WX661 Instruction Manual Page 10