Worx WU670L 250W Sonicrafter 110V User Manual

HigH frequency multi-function tool Wu670lSAFETY AND OPERATING MANUALORIGINAL INSTRUCTIONS

10Reposition the fastening piece (8) and tighten the bolt using the supplied Allen key.USING ADAPTERS (16) (See A3)Accessories of other brands ( Fein®

11and place it on again.MOUNTING THE SUCTION DEVICE (See C1-D2)When vacuuming, mount the suction device as shown in C1-D2.Note: Using the sanding pad

12SAWING WITH THE SEMICIRCLE SAW BLADEThe workpiece must be inserted firmly or clamped tightly before it is cut.Typical application: wood, PVC, soft me

13Working hints for your toolIf your power tool becomes too hot, especially when used at low speed, set the speed to maximum and run it with no load f

14Plug replacement (UK & Ireland only)If you need to replace the fitted plug then follow the instructions below.IMPORTANTThe wires in the mains

15EC DECLARATION OF CONFORMITYWe, Positec Power Tools (Europe) Ltd, PO Box 152, Leeds, LS10 9DS, UKDeclare that the product,Description WORX High fre

Copyright © 2011, Positec. All Rights Reserved.

2General power tool safety warnings Warning: Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result

3e) Do not overreach. Keep proper footing and balance at all times. This enables better control of the power tool in unexpected situations. f) Dress

467891011121314151617Always check walls and ceilings to avoid hidden power cables and pipes. A metal detector can be obtained from any good DIY store

5SymbolsTo reduce the risk of injury, user must read instruction manualDouble insulationWarningWear eye protectionWear dust mask Wear ear protectionWa

612345678910111213141516Component listVenting slotsScraper *Dust extraction attachment *Sanding paper *Sanding Pad Perforated *Sanding paper Perforate

7Technical dataVoltage 110V~50HzPower input 250WOscillating speed 11000-20000/minOscillating angle 3.2°Protection class /IIMachine weight 1.4

8••••••••••••Accessories Allen key 1End cut blade 1Sanding pad-dust extraction 1HSS semicircle saw blade 1Plastic sanding 1Carbide grit segment

91Operation instructionsNote: Before using the tool, read the instruction book carefully.INTENDED USEThe power tool is intended for sawing and separ