Worx WG155.5 Service Manual download pdf (Page 9)

1110

1110

2-in-1 Cordless Li-ion Grass Trimmer/Edger EN

ASSEMBLY

1. ASSEMBLY OF THE SAFETY GUARD

(See Fig A)

Fix the safety guard to the trimmer head

making sure the sides are located into the

grooves on the trimmer head.

Secure the safety guard onto the trimmer

head with the screw (a) provided.

2. ASSEMBLE OF THE EDGER WHEEL

(See Fig B)

Insert the edger wheel assembly onto grooves

of cutting head. Make sure the groove of the

wheel is locked in the metal plate.

Press the release button (b) on the wheel and

pull out to take off the wheel.

OPERATION INSTRUCTIONS

WARNING! The charger and battery

pack are specially designed to work

together so do not attempt to use any other

devices. Never insert or allow metallic objects

into your charger or battery pack connections

because of an electrical failure and hazard will

occur.

1. BEFORE USING YOUR CORDLESS

GRASS TRIMMER

Your battery pack is UNCHARGED and you must

charge once before use.

The battery charger supplied is matched to the

Li-ion battery installed in the machine. Do not

use another battery charger.

The Li-ion battery is protected against deep

discharging. When the battery is empty, the

machine is switched off by means of a protective

circuit: The trimmer head no longer rotates.

In a warm environment or after heavy use, the

battery pack may become too hot to permit

charging. Allow time for the battery to cool

down before recharging.

2. INSTALL THE CHARGER STANDS (See

Fig C)

Slide the two charger stands (c) into the both

grooves on back of the charger. The charger can

stand as shown in Fig.C.

3. HOW TO CHARGE YOUR BATTERY (See

Fig D)

Connect the battery charger to the power

supply and the green light (18) will illuminate.

Slide the battery pack into the charger to make

the connections. The green light (18) will be off

and the red light (19) will illuminate to show

charging has started. A discharged battery

at normal ambient temperature will take

approximately 0.5 hour to reach full charge.

When charging is completed the green light

(18) will illuminate while the red light (19) is

off.

NOTE:

This charger is designed to detect some

problems that can arise with battery pack. (see

table below)

4. TO REMOVE OR INSTALL BATTERY

PACK (See Fig E)

Depress the battery release button to

release battery pack from your trimmer.

After recharging, insert the battery pack into

trimmer’s battery port. A simple push and

slight pressure will be sufﬁcient.

5. SAFETY ON/OFF SWITCH (See Fig F)

Your switch is locked off to prevent accidental

starting. Depress lock off button (d) then on/off

switch (e) and release lock off button (d). Your

switch is now on. To switch off, just release the

on/off switch.

WARNING! The cutting head

continues to rotate after the

Red Flashing

Green Off

Defective battery, after

pre-charge some minutes

with trickle current, the total

battery voltage is still less

than 10.0V (When charging

18V battery pack).

Red ON

Green Off

Charging

Green ON

Red Off

Power On and Fully Charged

Green

Flashing

Red Off

The temperature of battery

pack is less than 32°F (0°C) or

more than 113°F (45°C)

1 2 3 4 5 6 7 8 9 10 11 12 13

Comments to this Manuals

No comments