3 IN 1 DRILL/DRIVER/IMPACT DRIVER WU288SAFETY AND OPERATING MANUALORIGINAL INSTRUCTIONS
10OPERATIONINSTALLING OR REMOVING A BIT HOLDER, SOCKET OR SCREWDRIVER BIT (See B)To install the desired bit, pull the collet locking sleeve (7) forwar
11chuck is rotating, wait until it has stopped!USING THE LED LIGHTTo turn on the light simply press the on/off switch. When you release the on/off swi
12set on a lower setting.Make the setting as follows:1 - 4 for driving small screws5 - 9 for driving screws into soft material10 - 14 for driving scre
13drill bits in good condition. Always use a magnetic bit holder (not included) when using short screwdriver bits. When screw-driving, apply a small q
14Plug replacement (UK & Ireland only)If you need to replace the fitted plug then follow the instructions below.IMPORTANTThe wires in the mains lea
15EC DECLARATION OF CONFORMITYWe, Positec Power Tools (Europe) Ltd,PO Box 152,Leeds, LS10 9DS, UKDeclare that the product,Description WORX 3 in 1 dri
Copyright © 2011, Positec. All Rights Reserved.
2General power tool safety warnings Warning! Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result
3e) Do not overreach. Keep proper footing and balance at all times. This enables better control of the power tool in unexpected situations. f) Dress
4hidden wiring. Fasteners contacting a “live” wire may make exposed metal parts of the power tool “live” and could give the operator an electric shock
5To reduce the risk of injury, user must read instruction manualWarningWear ear protectionWear eye protectionWear dust maskIndoor use onlyDo not expos
67 8 9123456Component list123456789Forward, reverse rotation and lock controlSoft grip handleBattery pack *Battery pack latchOn/off switch with variab
7Technical dataVoltage 12 V No load speedScrewdriver mode 0-600/min Drill mode (Lo-Hi) 0-600/ 0-2200/min Impact driver mode 0-2200/minImpact rate 0-30
8Helping to minimize your vibration exposure risk.ALWAYS use sharp chisels, drills and blades.Maintain this tool in accordance with these instructions
9Operating instructions Note: Before using the tool, read the instruction book carefully.INTENDED USEThe machine is intended for fastening and looseni
Comments to this Manuals