Worx WG308E Service Manual download pdf (Page 18)

Guarded electric chain saw EN

1918

1918

direction of the teeth (see Fig. H). The

cutting direction is inward on the lower

cutting edge.

9. With the mounting plate (a) toward the

motor and holding the chain in place on

the bar, feed bar and chain into the jaw,

angling over the bar locating pins (d) and

engaging the chain on the drive sprocket

(16) (See Fig I). There is little excess chain

length, therefore, the chain must be

properly ﬁtted in the bar slot to provide

enough extra chain to be pulled over the

drive sprocket.

10. Check if all parts are seated properly (See

Fig J).

11. Reﬁt and tighten the chain tensioner bolt.

Note the cam (e) of the tensioner will

engage the projecting tab (f) of the bar

mounting plate and push the bar outward

to tension the chain, check for correct

tension (See ADJUSTING THE CHAIN

TENSION).

12. Close the access cover and remove the

lock pin.

LUBRICATION

IMPORTANT: The JawSaw is shipped

with an empty oil tank. It is essential to

ﬁll with chain oil before use.

Never operate the JawSaw without

chain oil or an empty tank as this will

result in poor cutting performance,

motor overload and possible burn-out.

FILLING OIL TANK:

UNPLUG THE TOOL BEFORE FILLING

WITH OIL.

1. Fill oil bottle with bar oil. (See Fig. K)

2. Rest the JawSaw with the oil ﬁller (6) facing

upward

3. Lift the rubber oil ﬁller ﬂap (g) open.

4. Use bottle to ﬁll oil reservoir. (See Fig. L)

5. Close the ﬁller ﬂap by pressing the plug

part of the ﬂap into the oil ﬁller to seal. (See

Fig. M)

IMPORTANT: Use only the

recommended oil to avoid damage

to the JawSaw. Never use recycled/old oil.

Use of non approved oil will invalidate the

warranty.

CHECKING THE AUTOMATIC OILER

The JawSaw uses a much lower chain speed

than a conventional chainsaw so it needs

much less oil.

However is it very important that it always has

oil.

Check the oil tank window and reﬁll as

necessary.

During operation, periodically check the

chain and bar. A slight oil presence should be

visible. If the chain and bar appear completely

dry, then remove the bar and chain (see

previous section) to ensure the bar oil hole is

not blocked.

If the oil hole is clear, there is oil in the tank

and still no oiling of the chain is visible –

contact Worx customer service (contact 1-866-

354-9679).

OPERATION

PREPARE YOUR JAWSAW FOR USE

WARNING: Read and understand

all instructions. Failure to follow all

instructions listed may result in electric

shock, ﬁre and/or serious personal injury.

WARNING: Sharp moving blade.

To prevent accidental operation,

ensure that the tool is disconnected from

the power source before performing the

following operations, failure to do this

could result in serious personal injury.

CAUTION: Sharp moving blade.

Always wear protective gloves

when installing or removing the chain,

the chain is sharp and can cut you when

it is not running.

ATTACHING EXTENSION CORD

1. To prevent disconnection of appliance

cord, secure extension cord to extension

cord retainer.

2. An extension cord retainer is supplied to

reduce strain on the power cord. To use

this feature, form a loop at the end of the

extension cable and bring this through the

opening at the cable hook and suspend in

the tension relief at the hook. (See Fig N)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 59 60

Comments to this Manuals

No comments